anime
top

home
about us
product overview
technical bulletins
press release
contact
coolflow
thermox
solaris
fmp
sureflow
datasheets
staff

 

thermox fpg data sheet
coolflow
Heat transfer fluid for
solar heating systems

antifreeze optimumflow nontoxic biodegradeable corrosion quality
Anti-Freeze Optimum Flow Non Toxic Biodegradeable Corrosion Control Quality Assured

 

Product:
High Efficiency, Non-Toxic, High Temperature Rated Heat Transfer Fluid with Antifreeze Function. Based on Ethylene Glycol blended with the patented DeTox™ additive and Reversibly Evaporisible Inhibitors to prevent corrosion, scaling and biological fouling.
Density:
1.02 – 1.15 g/cm3 depending on inhibitors
PH:
7.5 – 10.5 depending on inhibitors.
Boiling point:
>100°C



properties

SOLARIS DTX has been especially formulated to exploit the advantages Ethylene Glycol has over Propylene Glycol. Specifically;

  • More efficient heat transfer.
  • Easier to pump, especially at low temperatures.
  • Less volume for the same freeze protection.
  • Cheaper per litre.

Although based on Ethylene Glycol, SOLARIS DTX has been tested and classified as Non-Toxic1 by an EPA2 certified laboratory. Previously Propylene Glycol was the only non-toxic glycol available. That is no longer the case.3

Hydratech in alliance with Evans Cooling Systems, Inc. have developed and patented the DeTox™ additive. DeTox™ prevents Ethylene Glycol from being metabolised (during digestion) into toxic by-products, which cause kidney failure, blindness and death.4 Tests carried out on SOLARIS DTX confirmed the toxicity was “so low that it was impossible to determine an LD505 value”.

The DeTox™ additive has very little effect on heat transfer or antifreeze performance. In fact similar volumes of SOLARIS DTX or Ethylene Glycol are required to achieve a specific freeze protection.

SOLARIS DTX is able to operate efficiently at ≤170°C for prolonged periods and withstand temperatures of 200°C for short periods. It contains reversibly evaporisable inhibitors that are capable of withstanding stagnation temperatures of 300°C whilst protecting all metals used in Solar systems.

SOLARIS DTX also contains a high temperature rated polyacrylate, formulated to prevent sludge precipitation and scale formation. Thus promoting long operational life and high thermal efficiency.

SOLARIS DTX mixtures are readily biodegradable (90% over ten days) and will not remain in the environment or bio-accumulate.

SOLARIS DTX is miscible with water in all proportions and can protect Solar Thermal Heating systems down to -55°C depending on concentration.

SOLARIS DTX exhibits super-cooling characteristics and mixtures containing in excess of 55% by volume do not freeze solid, alleviating any concern over possible expansion and burst damage.

SOLARIS DTX is a clear, slightly viscous liquid. It is mildly sweet to the taste and has a non-pungent but characteristic aroma.


application

As per BSRIA guide AG 1/2001.1 all pipe-work systems should be clean and free from biological contamination prior to commissioning.

To minimise corrosion air 6 ingress should be minimized. A pressurised system is best.

SOLARIS DTX is a concentrate Heat Transfer Fluid. It can be diluted with demineralised or Ultrapure™ water to achieve various freeze protection temperatures. In order to maintain system integrity only top-up with SOLARIS DTX.

Prior to dilution determine the system volume. Then add sufficient SOLARIS DTX according to the minimum ambient temperature expected. A minimum of 35% volume (v/v) is recommended.

E.g. 35% v/v SOLARIS DTX will provide -20°C protection, as might be expected for the UK mainland. Versus 40% v/v for Propylene Glycol based mixtures.

45% v/v SOLARIS DTX will provide -30°C protection, as might be expected for the Scottish Highlands. Versus 50% v/v for Propylene Glycol based mixtures.

Health & Safety: Please refer to the associated Safety Data Sheet.

Shelf Life: 3 years when stored in sealed containers out of direct sunlight.

Available in: 5, 10, 15, 20, 25, 205 & 1,000 litre containers and in bulk tankers.

SOLARIS DTX can also be supplied pre-mixed, as a Ready-To-Use solution.


mixing guide

SUREFLOW Support Services ensure that end users and distributors receive the full benefit of working with a specialist manufacturer. E.g.;

  • Fluid Maintenance Program; for the proactive verification of fluid and system condition.

application

1 According to the Hodge & Sterner Toxicity Scale, an LD50 rating between 500 – 5,000 mg/kg body-weight (bw) is classed as “Slightly Toxic” and anything above 15,000 mg/kg bw is classed as “Relatively Harmless” I.E. Non-Toxic.

2 EPA = United States Environmental Protection Agency.

3 SOLARIS DTX LD50 (Oral Rat) >21,000 mg/kg bw.
Propylene Glycol LD50 20,000 mg/kg bw.
Ethylene Glycol LD50 4,700 mg/kg bw.

4 According to the US Department of Health & Human Services as little as 150ml of Ethylene Glycol can lead to death and much smaller amounts can lead to renal failure in humans.

5 LD50 = Lethal Dose (oral) that causes the death of 50% of the lab rats.

6 Oxygen feeds the corrosion process and consumes inhibitors.

 

solarisdtx20
Ready-To-Use Heat Transfer Fluid, based on Solaris DTX blended with UltraPureTM water to achieve a frost protection of -20OC.

solarispgc
Non-Toxic High Temperature Rated Heat Transfer Fluid, with Antifreeze function, based on Propylene Glycol blended with BS6580 proven corrosion, scale and biological inhibitors.

solarispg20
Ready-To-Use Non-Toxic Heat Transfer Fluid, based on Solaris PGC blended with UltraPureTM water to achieve a frost protection of -20OC.

 

top
thermox coolflow
Home | About Us | Products | Technical Bulletins | Press Release | Contact Us | Coolflow | Thermox | Solaris | Purachem | Sureflow | Data Sheets | Staff
Hydra Technologies, Unit 5, Europa Way, Fforestfach, Swansea SA5 4AJ | Tel: 01792 586800 | Fax : 01792 561606 | info@hydratech.co.uk

Copyright ©2010 Hydra Technologies Limited. All Rights Reserved

Website and Logo by SiGGA Design Ltd